Protect your trunk from all your junk!
Trunk Armor™ is a urethane film manufactured by the leading automotive product manufacturer in the world. Trunk Armor™ contains every thing you need to install this fantastic protection product on your trunk lid. "Armor" your trunk lid from the scratches that will occur when any rack is placed on an unprotected trunk.
Trunk Armor™ is clear and almost invisible. The pictures above are actual pictures of a vehicle with Trunk Armor™ which was installed approximately 4 months ago. This Rack is put on and taken off at least four times a week. There are six Trunk Armor™ protective pads on the trunk lid shown above. Two 4"x6" Trunk Armor™ protective pads are on the rear of the trunk adjacent to the model insignias and there are two on the top of the trunk lid near the rear edge about one foot left and right of centerline. There are two smaller pieces at the bottom edge of the trunk protecting the license plate surround from the bicycle rack rubber bumpers. We wish that pictures can do justice for what this wonderful product looks like installed but my pictures are what you will see! With an almost undetectible edge .... it all but disappears!
Install an ARMOR PAD in 4 easy steps!
Download the easy to follow TRUNK ARMOR™ application instructions now.
Trunk Armor™ has an integrated clear coat system and can be buffed and waxed without damage. After waxing you may notice a miniscule accumulation of wax on the edge of Trunk Armor™ however, you easily remove the wax with a cloth just as you would with wax that gets on any trim piece of your vehicle
If you use a trunk rack without using the Trunk Armor™ protective kit you ARE scratching your vehicle.” -Dan Markovich, Markovich’s Auto Body
Thats right!!!!! If you put a rack on your Trunk whether it has foam bumpers or rubber feet it WILL scratch your finish. Road grime and water creates a paste that acts like sandpaper to your paint finish. Eventually vibration and small movements of the rack grind against your finish turning it dull, scratching it, or actually rubbing it away. Refinishing your trunk will COST YOU $$$ HUNDREDS OF DOLLARS $$$ Avoid the Damage! Keep your vehicle looking like the sharp ride that it is. Quit using rags, foam or some other material trailing in the wind reminding others of The Beverly Hillbillies !!!
Trunk Armor™ is compatible with any trunk rack that uses feet or bumpers that touch your trunk. Be creative!! Trunk Armor™ can be used to protect any painted surface and our kit provides extra material for you to experiment. The film can be easily trimmed with a razor blade. Film materials in larger pieces are available on a square foot basis. Call us toll free today for bulk pricing @ 1-877-832-6529 .
Complete Kit!
TRUNK ARMOR kit tube contains:
Four 4"x6" ARMOR pads
Four 3"x3" ARMOR pads
Two 3"x12" ARMOR pads
One Spray bottle for application liquid
One Application Squeegee
Instructions for easy installation
Easy on, Easy off
Simply position the TRUNK ARMOR™ film on your trunk and follow the easy to understand instructions. Spray the Film and Trunk with the application fluid, slide into place and squeegee out the air. It's just that easy!
To remove just gently warm the film with a hair dryer and lift an edge with you fingernail and pull the film from the surface leaving no residue or damage to your finish!
